GCM Mechanical

compressive strength of m25 concrete by using quarry dust

Products

  • Quarry Dust As Replacement For Sand In Concrete Pdf Ppt

    Use Of Quarry Dust To Replace Sand In Concrete An. Two grades of concrete M20 and M25 having nominal mix proportion of 11.53 and 112 respectively were used by weight and wc ratio was fixed according to the slump requirement of 60mm. For this concrete mix, quarry dust was added for replacement of sand from 0 to 100 in step of 10.

    Get Price
  • EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

    to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete. 1.2 NEED FOR INVESTIGATION Quarry Dust These residues are generally less than 1% aggregate production in the normal concrete. The introduction of quarry dust for mixing is limited due to its high fineness.

    Get Price
  • Research Article Study on Compressive Strength of Quarry

    Compressive strength of M20, M25, and M30 grade with 0.45 and 0.50 w/c F : CompressivestrengthofM,M,andMgradewith w/c . and . . grade also was observed with varying age of concrete by replacement level up to %. (c) e compressive strength results of quarry dust concrete (cubes) were obtained in the third series, where

    Get Price
  • Influence on Concrete Properties Using Multiple Corrosion

    inhabitor improves the compressive strength. M. Devi (2012) studied the strength and corrosion resisting properties of concrete containing quarry dust as fine aggregate along with calcium nitrate as corrosion inhibiting admixture at the dosage of 1%, 2%, 3% and 4% by weight of cement. The

    Get Price
  • COMPRESSIVE STRENGTH AND WORKABILITY OF

    dust. It therefore seems that for laterized quarry dust concrete, the best results – especially in terms of compressive strength – are obtained between 0 to 50% of lateritic sand content. The use of laterite and quarry dust as fine aggregate in concrete production has still not been generally

    Get Price
  • Studies on Pumice Lightweight Aggregate Concrete with

    Feb 08, 2016The lightweight concrete with the silica fume (SF), the superplasticizer (SP), and the quarry dust (QD) is added to the mix design, and then the beam is cured for 28 days, respectively, and the specimens are used for finding various parameters such as the compressive strength, the split tensile strength, and the flexural strength.

    Get Price
  • project of replacement of sand by quarry dust in concrete

    (PDF) Use of Quarry Dust to Replace Sand in Concrete – . This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive

    Get Price
  • Analysis of Concrete Made from Quarry Dust

    examples were casted for M25 grade of concrete by supplanting the cement 0%, 5%, 10%, 15% and 20% by quarry dust and tested for workability by slump test, compressive strength, flexure strength and split tensile test at the age of 7, 14, 28 and 50 days. concrete. Quarry dust is a byproduct that is generated from the

    Get Price
  • Compressive Strength Of Concrete While Use Quarry Dust

    compressive strength of m25 concrete by using quarry dust. Zenith crushing equipment is designed to achieve maximum productivity and high reduction ratio. From large primary jaw crusher and impact crusher to cone crusher and

    Get Price
  • is one of the important

    gradation of aggregates, workability, compressive strength and split tensile strength of concrete made using quarry dust as replacement of fine aggregate at 0, 25, 50, 75, and . Grade M15 of concrete was produced with ordinary Portland cement (OPC) for referral concrete while M25 of

    Get Price
  • Development of Enhanced Strength Concrete Using 10 Mm

    Development of Enhanced Strength Concrete Using 10 Mm (3/8") All-In Gravel and Quarry Dust as Aggregates. Civil Eng Res J. 2018; 3(2): 555607. DOI: 10.19080/CERJ.2018.03.5555607 0041 Ciil ngineerin Research ournal Statement of the problem This research work is aimed at obtaining concrete of medium compressive strength produced with 10mm

    Get Price
  • Use of Stone Dust as a substitute material in concrete: A

    the researchers worldwide. Compared to conventional concrete, the concrete incorporated with quarry dust has higher durability under sulphate attack and under acid action [6]. A. Compressive Strength Compressive strength is defined as the capacity of a material or structure to withstand loads tending to reduce size. It can

    Get Price
  • IOP Conference Series: Earth and Environmental Science

    The test result shows that CC with quarry dust has a greater value of 38.567 Mpa at 2% of fibre while CSC with Quarry dust has 25.50 Mpa at 4% of fibre. The mean compressive strength of the specimen is shown in Table 4 and Figure 1. S. No. Description Value 1. Maximum size used (mm) 12.500 2. Water Absorption (%) 24.000 3. Sp. Gravity 1.100 4.

    Get Price
  • Replacement of Sand in Concrete for Sustainable Building

    Aug 23, 2019The results of compressive strength test for quarry dust mix concrete (28 days) were as follows: Test Results of M20 M25 Grade of Concrete Contains Quarry Dust. The test result shows that, as the percentage of quarry dust gradually increases, the compressive strength of the concrete

    Get Price
  • Evaluation Of Mechanical And Durability Properties Of

    of quarry dust, 5 to 10% of Dolomite and Fly ash are used in concrete and on the strength or mechanical properties and durability properties of M25 grade concrete are studied. Quarry dust (for partil replacement of sand)Fly Ash and Dolomite as partial replacements

    Get Price
  • Partial Replacement Of Cement With Fly Ash And Cow Dung

    ash) and (40% fly ash +12% cow dung ash) and Fine aggregate is fully replaced by Quarry dust. The tests are performed compressive strength, workability of concrete, standard consistency and initial final setting time of cement. The M25 mix is design for proposed mix calculated for compressive strength test cube prepared for

    Get Price
  • IOP Conference Series: Materials Science and Engineering

    The slight variation is observed in compressive strength for 3 days and 7 days age in concrete. The compressive strength of M30 concrete has been tested for 3, 7, 28 days of curing with the percentage of quarry dust varying from 20%, 25% and 30% replacement. The compressive strength results are presented in Figure no. 5. 5. CONCLUSIONS It is

    Get Price
  • Properties of Micro Fine Quarry Dust Concrete

    that compressive strength increased with increasing days of curing. From figure 2 and 3, the compressive strength of OPC concrete for both w/b ratios were higher than the compressive strength of MFQD concrete. It also can be seen that both w/b ratios were showing the same trends, i.e. the compressive strength slightly decreased with increased

    Get Price
  • Effect on Properties of Concrete using Quarry Dust, Copper

    For there, M25 grade will be utilized with the age of 7 th, 14 th and 28 th days. Keywords: Quarry Dust, Copper Slag, Wood Ash, Compressive Strength, Split Tensile Strength, Flexural Strength, Workability. INTRODUCTION Cement is a coupling material utilized as a part of development exercises. The utilize of concrete is expanded as rate of

    Get Price
  • Effect of Partial Replacement of Cement by Fly Ash and

    4) T he 7 days compressive strength of cube is maximum for mix M3 than other diverse mixes with addition of 35% of fly ash in concrete mix. 5) Using fly ash, marble dust and stone dust waste in concrete mix proved to be very useful to solve environmental problems and reduces to some extent the requirement of cement in large quantity.

    Get Price
  • characteristics of quarry dust

    Mar 07, 2013the characteristics of quarry dust – Crusher South Africa. compressive strength of concrete from cement and quarry dust materials. compressive strength of concrete – Stone Crusher In India For Concrete is a combination of More detailed

    Get Price
  • IOP Conference Series: Materials Science and Engineering

    The slight variation is observed in compressive strength for 3 days and 7 days age in concrete. The compressive strength of M30 concrete has been tested for 3, 7, 28 days of curing with the percentage of quarry dust varying from 20%, 25% and 30% replacement. The compressive strength results are presented in Figure no. 5. 5. CONCLUSIONS It is

    Get Price
  • JOURNAL OF INTERNATIONAL ACADEMIC RESEARCH FOR

    compressive strength at 28 days for B5- type of concrete is highest so as per this study we can concluded that replacement of sand with quarry dust is possible. The compressive strength of concrete is almost 15% more than normal concrete. TABLE 2 Average Compressive Strength for 7, 14, 28 days Sr No. Concrete Mix Average Compressive Strength

    Get Price
  • CiteSeerX — Use of Quarry Dust to Replace Sand in Concrete

    Abstract- This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100 % in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature.

    Get Price
  • Partial Replacement of Sand by Quarry Dust in Construction

    Oct 25, 2017Abstract €" This experimental study focuses specially on the compressive strength of M20 and M25 grades of concrete on partial replacement of sand by Quarry dust

    Get Price
  • BEHAVIOUR OF CONCRETE ON THE USE OF QUARRY DUST TO REPLACE

    The compressive strength of concrete was tested in laboratory after 7, the hardened and durable properties of concrete using quarry dust were investigated. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm.

    Get Price
  • Studies on Pumice Lightweight Aggregate Concrete with

    Feb 08, 2016The lightweight concrete with the silica fume (SF), the superplasticizer (SP), and the quarry dust (QD) is added to the mix design, and then the beam is cured for 28 days, respectively, and the specimens are used for finding various parameters such as the compressive strength, the split tensile strength, and the flexural strength.

    Get Price
  • Strength of cold bonded quarry dust aggregate concrete

    concrete using quarry dust. Raman et.al. [6] evaluated the suitability of quarry dust as a partial substitute for sand in high-strength concrete (HSC) containing rice husk ash (RHA).The effect of high temperatures on the mechanical properties of concrete made with different types of aggregates was studied by Netinger et.al. [7] and

    Get Price
  • An Experimental study on uses of Quarry Dust to replace

    variation in the strength of concrete when replacing sand by quarry dust from 0% to in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at

    Get Price
  • Experimental Investigation on Quarry Dust and Recycled

    3. The compressive strength at the end of 28 days steadily decreases when the RA percentage is increased. However the compressive strength of M25 concrete at the end of 28 days for 30% replacement of RA and 20% of Quarry dust is 39 N/mm2 as shown in Table -8. 4. The compressive strength showed a steep decrease when the RA percentage is

    Get Price
  • An Experimental Study on Partial Replacement of Sand with

    Quarry dust can be used as an alternative to the river sand. Cost analysis shows that there is 40% savings if quarry dust is used instead of sand. Illangoan.R1 [2000] has done a study on replacement of sand by quarry dust in concrete. The compressive strength of

    Get Price
  • Stone Dust in Concrete: Effect on Compressive Strength

    the workability and compressive strength of concrete made using stone dust as partial replacement of fine aggregate in the range of 10% - . M25 grade of concrete was designed using Portland pozzolana cement (PPC) for referral concrete. Workability and Compressive strength were determined at

    Get Price